• High Strength antifouling, incorporating Biolux Technology that offers
protection in most fouling conditions.
• Self-Polishing Technology. Extended launching times. Quick Drying.
• Thinners: Antifouling Thinner No. 3
• For copper. Do not use on aluminum.
• Colors available: Black, Dover White, Red, Blue, Navy, and Dark Grey
Micron Extra 2 is a high strength antifouling, incorporating Biolux technology, that offers protection in most fouling conditions. Self polishing technology ensures a continuous renewal of the active layer of the paint which results in a hull that stays cleaner for longer and without a heavy build up of old paint. * Extended launching times * For use on fiberglass, wood and primed underwater metals (except aluminum) * Easy application * Available in a range of colours * Quick drying Colour: YBC700Dover White, YBC701 Red, YBC702 Blue, YBC703 Navy, YBC704 Black, YBC706 Dark Grey Finish: Matt Specific Gravity: 1.91 Volume Solids: 60% Typical Shelf Life: 2 years VOC (As Supplied): 348g/lt VOC (EU Solvent): 182 g/lt EU Solvent Emissions Directive (Council Directive 1999/13/EC) Unit Size: 4 Lt, 10 Lt
Available upon request
Preparation: PREVIOUSLY ANTIFOULED SURFACE In Good Condition Rinse with fresh water and allow to dry. If old antifouling is incompatible or unknown, seal with suitable International Paint barrier/sealer coat. In Poor Condition Remove all loosely adhering and flaking material, feather back all edges and sand all areas. Areas
taken back to substrate should be treated as for new work. If old antifouling is incompatible or unknown, seal with
suitable International Paint barrier/sealer coat. PRIMING For suitable primers, consult Yachtpaint.com or contact your local International Paint Representative. BARE GRP Degrease with solvent or suitable detergent cleaner. Sand well using 180220
grade paper. Clean thoroughly and allow to dry completely. Preprime using an International primer as detailed for specific coating systems. STEEL Degrease with solvent or suitable detergent cleaner. Gritblast to Sa 2½ near
white metal surface. If gritblasting is not possible, grind the metal surface with 2436 grit abrasive discs to a uniform, clean, bright metal surface with a 5075 microns anchor pattern. Use angle grinder on small areas. Clean thoroughly and allow to dry completely. Preprime using an International primer as soon as possible (within 8 hours) as detailed for specific coating systems.
BARE WOOD/PLYWOOD Sand smooth with 80180 and then 280 grade paper. Remove sanding dust by brushing,
dusting and wiping, or other suitable method. Clean down thoroughly and ensure surface is dry. .Prime using an International primer as detailed for specific coating systems. LEAD Degrease with solvent or suitable detergent cleaner. Sand well using 120 grade paper or power wire brush. Clean thoroughly and allow to dry. Preprime using an International primer as detailed for specific coating systems.
Hints: Mixing Stir well before use.
Thinning Not recommended
Available upon request
Available upon request
Disclaimer: Color Matching and Prices of each product will be available upon request.